Engineer IV

Overview

The Engineer III will be responsible for assisting in supporting the production build of various systems on the manufacturing floor. Responsible for planning and conducting independent work requiring judgment in the evaluation, selection, application, and adaptation of Manufacturing techniques, procedures, and criteria. Devise new approaches to problems, and prepare or modify drawings, specifications, calculations, charts, and graphs, and monitor work for compliance with applicable build and quality standards.

Essential Duties and Responsibilities

• Requires a broad knowledge of Manufacturing Practices, Assembly Prints, Bill of Materials to be able to create Manufacturing ready documentation such as S.O.E.’s (Sequence of Events) and Assembly Process Workflow.
• Establish process for manufacturing and create work instruction for assembly in MES System.
• Provides technical direction and on-the-job training to production staff.
• Evaluate manufacturing process and create process control plan, PFMEA and Risk assessment.
• Must comply to POR and CE! Compliance.
• Work with Manufacturing, Engineering, Quality department to drive Continuous improvement on quality, efficiency, and manufacturing cycle time.
• Initiate and support Design For Excellence and manufacturing process improvement / standardization.
• Engage with IE to optimize layout and product layout floor for new and existing plants
• Implement Lean line using DFT concept with relevant Jig and Fixture.
• Technical solve and support for trouble shooting issue, quality issue, first pass yield issue
• Participate in product transfer : Coordinate the team for training, understand the equipment, facility requirement, build and test requirements)
• Liaise and coordinate with Engineering and Material department on spec, BOM, and material changes / issues
• Liaise and coordinate with Quality department on Supplier quality and Customer quality issue including RCCA, 8D preparation.
• Liaise and coordinate with the Test Engineering department on testing development or testing issue
• Liaise with the customer for all BOM / drawing / design issue by generating a problem report / supplier problem sheet / Supplier request deviation with a single page summary.
• Involved in MRB (Material Review Board) meeting, make justifiable disposition, analyze data, and work with relevant departments / suppliers to reduce non-conformance.
• Minimum CAD knowledge to analyze 3D drawings from the customer.
• Initiate an Engineering change and waiver for any change required.
• Working in ERP System for engineering master control and change.

Other Duties

Knowledge, Skills and Abilities

Educational / Certification Requirement

Experience Requirement

At Ultra Clean Technology, we do not just welcome diversity - we celebrate it! Ultra Clean Technology is proud to be an equal opportunity employer. We are committed to equal employment opportunity regardless of race, color, national or ethnic origin, age, religion, disability, sexual orientation, gender, gender identity and expression, marital status, and any other characteristic protected under laws and regulations.

#J-18808-Ljbffr