Engineer III

Join UCT and be part of the fastest-growing sector in the world ! We indirectly touch every semiconductor chip that goes into every smartphone, smart car and device that uses artificial intelligence. This is a critical time for the semiconductor industry and for UCT - as technology evolves, we evolve with it. UCT is a diverse workplace where every talented employee is committed to continuous innovation, challenging the status quo and exceeding customer expectations. If you are a person with a relentless drive to succeed, a strong focus on quality with a passion for success – join us today!

UCT is looking for a talented Engineer III to join us in Malaysia!

Job Summary

Responsible to assist in supporting the production build of various systems on the manufacturing floor. Responsible for planning and conducting independent work requiring judgment in the evaluation, selection, application and adaptation of Manufacturing techniques, procedures and criteria. Devise new approaches to problems, and prepare or modify drawings, specifications, calculations, charts and graphs, and monitor work for compliance to applicable build and quality standards.

Essential Duties and Responsibilities

• Requires a broad knowledge of Manufacturing Practices, Assembly Prints, Bill of Materials to be able to create Manufacturing ready documentation such as S.O.E.’s (Sequence of Events) and Assembly Process Workflow.
• Establish process for manufacturing and create work instruction for assembly in MES System.
• Provides technical direction and on-the-job training to production staff.
• Evaluate manufacturing process and create process control plan, PFMEA and Risk assessment.
• Must comply to POR and CE! Compliance.
• Work with Manufacturing, Engineering, Quality department to drive Continuous improvement on quality, efficiency and manufacturing cycle time.
• Initiate and support Design For Excellence and manufacturing process improvement / standardization.
• Engage with IE to optimize layout and product layout floor for new and existing plants
• Implement Lean line using DFT concept with relevant Jig and Fixture.
• Technical solve and support for trouble shooting issue, quality issue, first pass yield issue
• Participate in product transfer : Coordinate the team for training, understand the equipment, facility requirement, build and test requirements)
• Liaise and coordinate with Engineering and Material department on spec, BOM and material changes / issues
• Liaise and coordinate with Quality department on Supplier quality and Customer quality issue including RCCA, 8D preparation.
• Liaise and coordinate with Test Engineering department on testing development or testing issue
• Liaise with customer for all BOM / drawing / design issue by generating problem report / supplier problem sheet / Supplier request deviation with single page summary.
• Involve in MRB (Material Review Board) meeting, make justifiable disposition, analyst data and work with relevant departments / suppliers to reduce non-conformance.
• Minimum CAD knowledge to analyst 3D drawing from customer.
• Initiate Engineering change and waiver for any change required.
• Working in ERP System for engineering master control and change.

Other Duties

Knowledge, Skills and Abilities

Educational / Certification Requirement

Experience Requirement

#J-18808-Ljbffr